How much do you know about the surface treatment methods of gears?

Galvanized 　　Zinc plating is to improve the rust resistance of metals. With the progress of chromate passivation treatment, the appearance performance has also been greatly improved. The thickness of the coating is generally about 2~25μm Electroless Nickel 　　The chemical nickel plating has high corr... read more

Brief description of several common fault forms of gears and preventive measures

 1. Fatigue of tooth surface (pitting, flaking) 　　 Causes and phenomena: It is mainly due to micro fatigue cracks caused by alternating stress on the working surface. After the lubricant enters the crack, due to the meshing process, the inlet may be closed and then squeezed. The lubricant in the mic... read more

What is the rear axle of the car and how to improve it?

According to statistics, the rear axle of the car refers to the package bridge behind the car. If it is a car driven by the front axle assembly, then the rear axle of the car is just a steering headlight bridge, which only has a load-bearing effect. At the moment, in addition to the load-bearing eff... read more

What are the relevant introductions and classifications of half-shaft gears?

Generally speaking, the gear refers to a single gear part. Generally, the gear and the shaft are connected and used in some way, such as spline, shear flat key, etc. In special cases, when the gear is small and the shaft is thick, the general method of connection makes the shaft and the shaft The st... read more

How much do you know about gears?

Number of teeth z The total number of teeth of a gear. Rack is a special gear with teeth distributed on the bar. Racks are also divided into straight racks and helical racks, which are paired with straight and spur gears, respectively; the tooth profile of the rack is straight rather than involute (... read more